MeshTruncatedCone
| Toolbar | Menu |
|---|---|
|
|
Mesh Polygon Mesh Primitives > Truncated Cone |
MeshTruncatedCone 指令建立一个网格平顶锥体。
Steps
-
Draw the base circle.
-
Pick a location or type a number to set the height.
The positive direction of the height is different based on the selected DirectionConstraint option.
-
Draw the end circle.
圆柱管底面选项
DirectionConstraint
Controls how the direction of the truncated cone is defined.
None
The direction is defined by the position of the mouse cursor.
- Use elevator mode, object snaps, or other modeling aids to help picking a location.
- The cursor location is the positive direction when you type a number to set the height.
Vertical
Creates a truncated cone perpendicular to the construction plane.
- The CPlane +Z direction is the positive direction when you type a number to set the height.
AroundCurve
Draws the base circle perpendicular to the picked point on a curve. The center line of the truncated cone will be tangent to the curve.
- The curve direction is the positive direction when you type a number to set the height.
实体
给顶部和底部开口处加盖或者保持其开放状态。
Radius
Draws the base circle by picking the center point and a radius point.
2Point
Draws the base circle from two opposite points.
3Point
Draws the base circle through three points.
Tangent
Draws the base circle tangent to one, two, or three curves.
FitPoints
Draws the base circle by fitting to selected points, control points, or mesh vertices.
垂直面数
设定垂直方向上的网格面的数目。
环绕面数
围绕在一周的面的数量。
加盖类型（三角面/四边面）
选择使用三角面或四边面来填充顶部和底部开口。
- This option is only visible when AroundFaces is an even number (4, 6, 8...), and Solid=Yes.
- Tri is always used when AroundFaces is an odd number.
End circle options
Radius
Pick a location or enter a number to set the end circle radius.
Diameter
Pick a location or enter a number to set the end circle diameter.
请参考
TruncatedCone
Draw a NURBS truncated cone.
SubDTruncatedCone
Creates a subdivision truncated cone object.